Loading article...
Loading article...
Stream/Area:
-
Subject:
-
Paper ID:
10.55041/IJSREM12403
Volume:
6 |
4 |
Apr 2022
Pages:
Publication Frequency:
Monthly (12 issues per year)
License:International Journal of Scientific Research in Engineering and Management follows the Creative Commons Attribution 4.0 (CC BY 4.0) License, allowing free use and distribution with proper attribution.
Wire and arc additive manufacturing (WAAM) has proven that it can produce medium to large size components because of its high rate of deposition and potentially unlimited build size. Moreover, AM, particularly WAAM, is no longer just not only a prototyping technology but also a great benefit on its transformation to a viable and cost-effective production. So, we are planning to create the 3D object using WAAM technology so that we can check the properties of the 3D object that is created by using WAAM technology. Many of the projects are based on additive manufacturing and we intend use the same concept but most of the additive manufacturing technologies are limited to low-melting point-based materials, thus we planned to use the WAAM as the additive manufacturing method to create the 3D object.
KEYWORDS
Publication Date
4/24/2022
Peer Review Type
Double-Blind Peer Review
Review Rounds: 2
Documents
Article Views
0
Total views since publication
PDF Downloads
1
Total downloads since publication
Geographic Reach
5
Digital Preservation: This article is permanently archived on Zenodo and complies with all data preservation standards across major indexing platforms.
Plagiarism Screening
This manuscript has been checked for plagiarism using TurnitinPlagiarismChecker software.
Conflict of Interest
The authors declare no conflict of interest related to this research work.
Funding Information
No funding information available for this research.
Related research in the same subject area
Loading similar articles...