Loading article...
Loading article...
Stream/Area:
-
Subject:
-
Paper ID:
IJSREM68802
Volume:
10 |
11 |
Nov 2026
Pages:
1-10
Publication Frequency:
Monthly (12 issues per year)
License:International Journal of Scientific Research in Engineering and Management follows the Creative Commons Attribution 4.0 (CC BY 4.0) License, allowing free use and distribution with proper attribution.
Civil Engineering
Sanketika Vidya Parishad Engineering College
Assistant Professor, Department of Civil Engineering,
Sanketika Vidya Parishad Engineering College, P.M. Palem, Visakhapatnam – 530041, Andhra Pradesh, India
Warm mix asphalt (WMA) reduces production temperature and emissions compared with hot mix asphalt (HMA), but concerns remain about its moisture susceptibility and durability. This study produces WMA without chemical additives by a two-phase mixing process (TPMP), in which aggregates are pre-coated with a medium-setting bitumen emulsion and then mixed with VG-30 bitumen at reduced temperature. The binder is then modified with graphene oxide (GO) and reduced graphene oxide (RGO). From HMA trials, 8% GGBFS was selected as the best filler, giving a Marshall stability of 14.04 kN. Among WMA mixes made at 110, 120 and 130 °C with bitumen-to-emulsion ratios (BTER) of 100:0 to 50:50, the mix at 120 °C and 80:20 performed best. It gave a stability of 12.35 kN, a TSR of 88%, a retained Marshall stability of 76.54% and a rut depth of 4.12 mm. Adding GO and RGO at 0.1–0.5% by weight of bitumen raised the softening point and reduced penetration and ductility, and 0.3% was optimum for both. At 0.3%, the GO- and RGO-modified WMA reached stabilities of 16.28 and 16.13 kN, about 31% above the unmodified WMA. The GO-modified WMA gave an ITS of 680 kPa and a TSR of 88.3%, a rut depth of 3.91 mm at 50 °C (close to 3.48 mm for HMA) and a ravelling loss of 11.8%, 35% lower than HMA. Graphene-modified WMA prepared by TPMP thus offers HMA-comparable performance at a lower production temperature.
KEYWORDS
1. GGBFS at 8% by weight of aggregate was the best filler for the DBM mix, giving an HMA stability of 14.04 kN, 27.28% and 13.39% higher than with stone dust and cement fillers. 2. Additive-free WMA can be produced by the two-phase mixing process; the mix prepared at 120 °C with an 80:20 bitumen-to-emulsion ratio was best, with a stability of 12.35 kN, a TSR of 88%, an RMS of 76.54% and a rut depth of 4.12 mm, close to HMA. 3. GO and RGO raised the softening point and reduced the penetration and ductility of bitumen in both unaged and PAV-aged states; 0.3% by weight of bitumen was optimum for the mixtures. 4. At 0.3%, GO- and RGO-modified WMA reached stabilities of 16.28 and 16.13 kN, about 31% above unmodified WMA and above HMA. 5. GO-modified WMA improved ITS to 680 kPa and TSR to 88.3%, reduced the rut depth at 50 °C from 5.52 to 3.91 mm, and reduced the ravelling loss to 11.8%, 35% below HMA; RGO gave the highest RMS among the WMA mixes (79.21%). 6. Graphene-modified WMA prepared by TPMP provides performance comparable to HMA at a production temperature 30–40 °C lower, offering an energy-efficient and durable alternative. Field trials, fatigue and low-temperature cracking tests, and life-cycle cost and emission assessments are recommended before large-scale use.
[1] H. K. Behera, N. Pattanayak, D. Giri, and S. S. Das, "Predictive modeling of graphene-modified warm-mix asphalt: Integrating rheology and stress sensitivity," Journal of Transportation Engineering, Part B: Pavements, vol. 152, no. 1, 2026, doi: 10.1061/JPEODX.PVENG-1916. [2] Y. Zhao, R. Guo, J. Li, and L. Wen, "Research on preparation and road performance of graphene oxide framework modified asphalt and asphalt mixture based on micro-mechanism and grey correlation analysis," Construction and Building Materials, vol. 462, Art. no. 139980, 2025, doi: 10.1016/j.conbuildmat.2025.139980. [3] T. Li, K. Jiang, K. Liu, and Q. Li, "Fourier transform infrared spectroscopy characterization of aging properties of graphene oxide modified asphalt binder," International Journal of Adhesion and Adhesives, vol. 139, Art. no. 103974, 2025, doi: 10.1016/j.ijadhadh.2025.103974. [4] W. Zhu and A. Zhang, "Uniform dispersion of graphene in asphalt emulsion using an aerosol-based approach: An experimental–simulation study," Construction and Building Materials, vol. 489, Art. no. 142170, 2025, doi: 10.1016/j.conbuildmat.2025.142170. [5] T. Guo, Z. Li, Y. Chen, Q. Xu, J. Wang, and L. Jin, "Study on the performance and mechanism of graphene oxide/polyurethane composite modified asphalt," Scientific Reports, vol. 15, Art. no. 2482, 2025, doi: 10.1038/s41598-025-86078-9. [6] F. Maltinti, J. Rombi, and M. Coni, "Improving pavements through an innovative asphalt graphene-modified thin layer: A case study," Transportation Engineering, vol. 21, Art. no. 100367, 2025, doi: 10.1016/j.treng.2025.100367. [7] M. T. A. Sarkar, M. A. Elseifi, and Z. Hossain, "Effects of warm-mix additives, anti-stripping agent, and graphene nanoplatelet on the cracking resistance, moisture susceptibility, and cost effectiveness of stone mastic asphalt," Construction and Building Materials, vol. 438, Art. no. 137250, 2024, doi: 10.1016/j.conbuildmat.2024.137250. [8] H. Hamedi, F. Moghadas Nejad, and A. Azarhoosh, "Assessing the influence of nano graphene oxide application in mitigating the adverse effects of runoff pH on the moisture susceptibility of asphalt concretes," Construction and Building Materials, vol. 438, Art. no. 137182, 2024, doi: 10.1016/j.conbuildmat.2024.137182. [9] H.-G. T. Hoang, H.-L. Nguyen, and H.-B. Ly, "Evaluation of the performance enhancement of asphalt concrete via graphene oxide incorporation: A multi-test approach," Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications, vol. 239, no. 6, 2025, doi: 10.1177/14644207241282113. [10] M. T. A. Sarkar and M. A. Elseifi, "Experimental evaluation of asphalt mixtures with emerging additives against cracking and moisture damage," Journal of Road Engineering, vol. 3, no. 4, pp. 336–349, 2023, doi: 10.1016/j.jreng.2023.07.001.
Publication Date
11/6/2026
Peer Review Type
Double-Blind Peer Review
Review Rounds: 2
Documents
Article Views
0
Total views since publication
PDF Downloads
4
Total downloads since publication
Geographic Reach
5
Digital Preservation: This article is permanently archived on Zenodo and complies with all data preservation standards across major indexing platforms.
Plagiarism Screening
This manuscript has been checked for plagiarism using TurnitinPlagiarismChecker software.
Conflict of Interest
The authors declare no conflict of interest related to this research work.
Funding Information
No funding information available for this research.
Related research in the same subject area
Loading similar articles...