Loading article...
Loading article...
Stream/Area:
-
Subject:
-
Paper ID:
IJSREM23937
Volume:
7 |
6 |
Jun 2023
Pages:
Publication Frequency:
Monthly (12 issues per year)
License:International Journal of Scientific Research in Engineering and Management follows the Creative Commons Attribution 4.0 (CC BY 4.0) License, allowing free use and distribution with proper attribution.
This paper describes an investigation on the effect of using two different filler metals to weld two dissimilar metals namely, stainless steel 304 and MS plates with two filler metals Including ER316L and ER70S were selected to weld the two plates Radiography and penetrant tests were performed on the welded metals to ensure the surface and internal soundness. The tensile strength of all the welded samples is found to be in between the tensile strength of the base metals. Micro-hardness test showed that weld has the highest hardness, meanwhile hardness profile of ER316L presented a sharp drop in the stainless- steel side and ER70S weld metal illustrated hardness above the two base metals with fewer variations across the weld metal.
KEYWORDS
Publication Date
6/26/2023
Peer Review Type
Double-Blind Peer Review
Review Rounds: 2
Documents
Article Views
0
Total views since publication
PDF Downloads
1
Total downloads since publication
Geographic Reach
5
Digital Preservation: This article is permanently archived on Zenodo and complies with all data preservation standards across major indexing platforms.
Plagiarism Screening
This manuscript has been checked for plagiarism using TurnitinPlagiarismChecker software.
Conflict of Interest
The authors declare no conflict of interest related to this research work.
Funding Information
No funding information available for this research.
Related research in the same subject area
Loading similar articles...