Crossref DOIMemberCiteFactoropen accessissn
SJIF Impact Factor 8.659 | ISSN: 2582-3930
IJSREM Logo

International Journal of Scientific Research in Engineering and Management

(Gateway to Global Scholars - An International, Scholarly, Multi-Disciplinary, Open Access Journal)

Peer-Reviewed Journal Designed to Meet UGC's Quality Parameters

HomeCurrent IssuePast IssuesPay OnlineConferencesEditorial BoardAbout UsContact Us
IJSREM

Loading article...

Follow Us

  • Google Scholar
  • ResearchGate
  • Academia.edu
  • Mendeley
  • LinkedIn
  • Facebook
  • Instagram

Journal Policies

  • Peer Review Policy
  • Publication Ethics
  • Copyright Infringement
  • Refund & Cancellation Policy
  • Terms and Conditions
  • Privacy Policy

Journal Identifiers & Licenses

  • ISSN Verified: 2582-3930ISSN Verified: 2582-3930
  • Crossref DOI: 10.55041Crossref DOI: 10.55041
  • SJIF Ranking: 08.659SJIF Ranking: 08.659
  • Licensed under CC BY 4.0Licensed under CC BY 4.0
  • ISO Certification: 9001:2015ISO Certification: 9001:2015
  • Indexed & Cited In: Google ScholarIndexed & Cited In: Google Scholar

Contact Us

International Journal of Scientific Research in Engineering and Management (IJSREM)

#62/1, New No 7, 1st Cross, 2nd Main, Ganganagar, R T Nagar, Bangalore North, Bangalore, Karnataka, India – 560032
[email protected]+91 93911 67991
logos
logos
Working Hours

Mon – Sat: 9:00 AM – 6:00 PM

Sunday: 10:00 AM – 4:00 PM

+91 93911 67991

© 2026 IJSREM – International Journal of Scientific Research in Engineering and Management. This is an open-access journal. Articles are published under the Creative Commons Attribution (CC BY 4.0) License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

DisclaimerPrivacy PolicyTerms and Conditions
ArticlePeer ReviewedOpen AccessPlagiarism Passed
Paper ID:IJSREM68942

EXPERIMENTAL INVESTIGATION OF THE INFLUENCE OF NANO-SILICA AND NATURAL FIBRES ON THE MECHANICAL AND DURABILITY PROPERTIES OF CONCRETE

Stream/Area:

-

Subject:

-

Paper ID:

IJSREM68942

Volume:

10 |

11 |

Nov 2026

Pages:

1-8

Publication Frequency:

Monthly (12 issues per year)

DOI
Digital Object Identifier
10.55041/IJSREM68942

License:International Journal of Scientific Research in Engineering and Management follows the Creative Commons Attribution 4.0 (CC BY 4.0) License, allowing free use and distribution with proper attribution.

Share this article:

Authors

DRP

DOKKARA RAGHAVA PRASANTHI

Department of Civil Engineering

Sanketika Vidya Parishad Engineering College, P.M. Palem, Visakhapatnam – 530041, Andhra Pradesh, India

Download Author Certificate

Mentors

KDC

K. DILEEP CHOWDARY

Department of Civil Engineering

Sanketika Vidya Parishad Engineering College, P.M. Palem, Visakhapatnam – 530041, Andhra Pradesh, India

Download Mentor Certificate

Author Services & Downloads

Full ArticlesAcceptance Certificate

Abstract

This study experimentally evaluates the influence of nano-silica (NS) and three natural fibres—pineapple fibre (PAF), sisal fibre (SF) and bamboo fibre (BF)—on the fresh, mechanical and selected durability properties of M25 concrete. Cement was partially replaced with NS at 1–4% by mass, while each fibre was investigated separately over dosage ranges of 0.25–1.0% for PAF, 0.25–1.25% for SF and 0.25–1.50% for BF. Compressive, split tensile and flexural strengths were determined at 7 and 28 days. The reported 28-day compressive strength increased from 35.33 MPa for the control mixture to 45.70 MPa at 3% NS, corresponding to an increase of approximately 29.35%; split tensile and flexural strengths increased from 4.16 to 4.73 MPa and from 4.22 to 4.78 MPa, respectively. Among the fibre mixtures, the maximum reported 28-day compressive strengths were 39.92 MPa at 0.75% PAF, 40.02 MPa at 1.0% SF and 40.43 MPa at 1.25% BF. The maximum 28-day split tensile strength was 5.02 MPa at 1.25% BF. Selected mixtures containing 3% NS and 1.25% BF exhibited lower reported mass and compressive-strength losses after 30-day chemical immersion than the control. No water was collected during the three-day permeability test; the calculated coefficient was consequently reported as zero. Although reinforced-concrete beam testing and ANSYS analysis are mentioned in the study description, corresponding numerical results are unavailable; structural performance is therefore not quantified. The findings are subject to limitations arising from incomplete data tables and inconsistent mix descriptions.

KEYWORDS

Nano-silica natural fibre pineapple fibre sisal fibre bamboo fibre M25 concrete compressive strength durability.

Cite This Article

DOKKARA RAGHAVA PRASANTHI, K. DILEEP CHOWDARY, "EXPERIMENTAL INVESTIGATION OF THE INFLUENCE OF NANO-SILICA AND NATURAL FIBRES ON THE MECHANICAL AND DURABILITY PROPERTIES OF CONCRETE," International Journal of Scientific Research in Engineering and Management, vol. 10, no. 11, pp. 1-8, Nov 2026. https://doi.org/10.55041/IJSREM68942

Full Article/Conclusion

1.      Among the investigated NS replacement levels, 3% NS produced the highest reported 28-day strengths: 45.70 MPa in compression, 4.73 MPa in split tension and 4.78 MPa in flexure. 2.      The natural fibres improved the reported mechanical properties up to fibre-specific optimum contents. The maximum 28-day compressive strengths were 39.92 MPa at 0.75% PAF, 40.02 MPa at 1.0% SF and 40.43 MPa at 1.25% BF. 3.      The highest reported 28-day split tensile strength was 5.02 MPa for the mixture containing 1.25% BF, approximately 20.7% higher than the control value. 4.      Fibre addition reduced slump, with the largest reduction reported for BF at higher dosage. Workability control is therefore important when incorporating natural fibres. 5.      The combined mixture containing 3% NS and 1.25% BF exhibited the highest reported Young’s modulus and the lowest mass and compressive-strength losses among the four mixtures included in the durability programme. 6.      No measurable water discharge was recorded during the three-day permeability test. This is a test-specific observation and does not establish zero permeability under all conditions.

References

[1] F. Zhu, H. Qiao, and J. Li, “Sulfate attack resistance and reliability analysis of fibre-reinforced concrete materials,” Emerging Materials Research, vol. 9, no. 4, pp. 1121–1130, 2020, doi: 10.1680/jemmr.20.00110. [2] M. D. de Klerk, M. Kayondo, G. M. Moelich, W. I. de Villiers, R. Combrinck, and W. P. Boshoff, “Durability of chemically modified sisal fibre in cement-based composites,” Construction and Building Materials, vol. 241, Art. no. 117835, 2020, doi: 10.1016/j.conbuildmat.2019.117835. [3] J. Ahmad and Z. Zhou, “Mechanical properties of natural as well as synthetic fiber reinforced concrete: A review,” Construction and Building Materials, vol. 333, Art. no. 127353, 2022, doi: 10.1016/j.conbuildmat.2022.127353. [4] J. Liu, X. Xie, and L. Li, “Experimental study on mechanical properties and durability of grafted nano-SiO₂ modified rice straw fiber reinforced concrete,” Construction and Building Materials, vol. 347, Art. no. 128575, 2022, doi: 10.1016/j.conbuildmat.2022.128575. [5] M. Tabish, M. M. Zaheer, and A. Baqi, “Effect of nano-silica on mechanical, microstructural and durability properties of cement-based materials: A review,” Journal of Building Engineering, vol. 65, Art. no. 105676, 2023, doi: 10.1016/j.jobe.2022.105676. [6] F. Althoey, O. Zaid, R. Martínez-García, F. Alsharari, M. Ahmed, and M. M. Arbili, “Impact of nano-silica on the hydration, strength, durability, and microstructural properties of concrete: A state-of-the-art review,” Case Studies in Construction Materials, vol. 18, Art. no. e01997, 2023, doi: 10.1016/j.cscm.2023.e01997. [7] J. Liu, W. Zhao, and L. Li, “Effects of nano-SiO₂ grafting on improving the interfacial and mechanical properties of concrete with rice straw fibers,” Construction and Building Materials, vol. 398, Art. no. 132516, 2023, doi: 10.1016/j.conbuildmat.2023.132516. [8] V. S. Kashyap, G. Sancheti, J. S. Yadav, and U. Agrawal, “Smart sustainable concrete: Enhancing the strength and durability with nano silica,” Smart Construction and Sustainable Cities, vol. 1, Art. no. 20, 2023, doi: 10.1007/s44268-023-00023-1. [9] K. Karthik et al., “State of the art: Natural fibre-reinforced composites in advanced development and their physical/chemical/mechanical properties,” Chinese Journal of Analytical Chemistry, vol. 52, no. 7, Art. no. 100415, 2024, doi: 10.1016/j.cjac.2024.100415. [10] T. A. Fode, Y. A. C. Jande, T. Kivevele, and N. Rahbar, “Effect of waste water bottle and treated sisal fibers on the durability and mechanical properties of concrete,” Scientific Reports, vol. 15, Art. no. 7945, 2025, doi: 10.1038/s41598-025-92306-z.

Editorial & Review Transparency

Publication Date

11/13/2026

Peer Review Type

Double-Blind Peer Review

Review Rounds: 2

Documents

Review Report (Confidential)
Copyright Form (Office)

Article Metrics & Impact

Article Views

0

Total views since publication

PDF Downloads

4

Total downloads since publication

Geographic Reach

5

Indexing, Archiving & Preservation

Google Scholar
Academia
ResearchGate
Crossref
SSRN
Semantic Scholar
Thomson Reuters
WorldCat
Mendeley
OpenAlex
EBSCO
Zenodo

Digital Preservation: This article is permanently archived on Zenodo and complies with all data preservation standards across major indexing platforms.

Ethics, Compliance & Transparency

Plagiarism Screening

This manuscript has been checked for plagiarism using TurnitinPlagiarismChecker software.

Conflict of Interest

The authors declare no conflict of interest related to this research work.

Funding Information

No funding information available for this research.

Similar & Recommended Articles

Similar Articles by Topic

Related research in the same subject area

Loading similar articles...