Loading article...
Loading article...
Stream/Area:
-
Subject:
-
Paper ID:
IJSREM68947
Volume:
10 |
11 |
Nov 2026
Pages:
1-7
Publication Frequency:
Monthly (12 issues per year)
License:International Journal of Scientific Research in Engineering and Management follows the Creative Commons Attribution 4.0 (CC BY 4.0) License, allowing free use and distribution with proper attribution.
Department of Civil Engineering
Sanketika Vidya Parishad Engineering College, P.M. Palem, Visakhapatnam – 530041, Andhra Pradesh, India
Department of Civil Engineering
Sanketika Vidya Parishad Engineering College, P.M. Palem, Visakhapatnam – 530041, Andhra Pradesh, India
Expansive black cotton soils exhibit substantial volume change with moisture variation and often require stabilization before use as pavement subgrade. This study examines the individual and combined effects of copper slag (CS) and polypropylene (PP) fibre on compaction, unconfined compressive strength (UCS) and California Bearing Ratio (CBR). CS was investigated at 6–24% of dry soil mass, PP fibre at 0.5–2.0%, and combined mixtures at CS contents of 3–12% with corresponding PP contents of 0.5–2.0%. The reported UCS reached 1.722 kg/cm² at 6% CS and 0.944 kg/cm² at 0.5% PP fibre. The maximum unsoaked CBR values in the individual series were 4.89% for 6% CS and 5.80% for 0.5% PP fibre. For combined mixtures, the highest unsoaked CBR was 5.81% at 6% CS + 1% PP, while the corresponding soaked CBR was 1.93%. The combined mixtures did not demonstrate a consistent UCS advantage over individual stabilizers. Important inconsistencies occur in compaction values, units, mix nomenclature and test reporting; several planned swelling tests have no numerical results. Findings are therefore treated as preliminary laboratory observations, not a validated optimum design.
KEYWORDS
1. The maximum reported UCS in the CS series was 1.722 kg/cm² at 6% CS; the PP series maximum was 0.944 kg/cm² at 0.5% fibre. 2. Maximum unsoaked CBR values in individual series were 4.89% at 6% CS and 5.80% at 0.5% PP fibre. 3. For combined mixtures, 6% CS + 1% PP produced the highest unsoaked CBR (5.81%), while 3% CS + 0.5% PP produced the highest soaked CBR (2.58%). 4. Soaking reduced the combined-mixture CBR substantially; for 6% CS + 1% PP it decreased from 5.81% to 1.93%. 5. Combined UCS values declined as paired additive contents increased and did not establish a synergistic benefit over the individual-treatment maxima. 6. Compaction values require verification. Further replicated testing, complete soaked CBR comparisons, swelling tests, leaching assessment and field validation are necessary before recommending a subgrade mix.
[1] M. I. Malik, A. Sharma, and A. Senagah, “Coupled chemical–mechanical stabilization of expansive subgrade soil using cement kiln dust and polypropylene fibers for flexible pavement performance,” Scientific Reports, 2026, doi: 10.1038/s41598-026-59154-x. [2] O. P. Navagire, V. Srinivasan, A. Patel, and D. Gowrisankar, “Stabilization of expansive soils using polypropylene fiber for enhanced engineering properties: A study on black cotton soils from India,” Indian Geotechnical Journal, vol. 56, no. 3, pp. 1445–1461, 2025, doi: 10.1007/s40098-025-01225-3. [3] P. P. Vilasini, T. S. Lakshmi, V. Sree Lakshmi, and M. A. K. Reddy, “Optimized synergy of copper slag and marble dust for enhanced properties of expansive clay,” Progress in Engineering Science, vol. 2, no. 3, Art. no. 100115, 2025, doi: 10.1016/j.pes.2025.100115. [4] H. N. Sridhar et al., “Experimental investigation of the engineering properties of stabilized black cotton soil using industrial waste materials,” Transportation Infrastructure Geotechnology, vol. 12, Art. no. 18, 2025, doi: 10.1007/s40515-024-00477-5. [5] M. F. Yazıcı and N. Keskin, “Experimental investigation of the mechanical properties of polypropylene fiber-reinforced clay soil and development of predictive models,” Arabian Journal for Science and Engineering, vol. 49, pp. 13593–13611, 2024, doi: 10.1007/s13369-023-08688-7. [6] G. Bharti et al., “Environmental impact analysis and utilization of copper slag for stabilising black cotton soil,” Materials Today: Proceedings, 2023, doi: 10.1016/j.matpr.2023.04.305. [7] A. U. Rao et al., “Effect of polypropylene macro fiber on geotechnical characteristics of black cotton soil,” Engineered Science, vol. 21, Art. no. 775, 2023, doi: 10.30919/es8d775. [8] H. Gadouri and B. Meziani, “Strength improvement using polypropylene fiber as reinforcement in natural pozzolana-lime-stabilized expansive clayey soil,” Periodica Polytechnica Civil Engineering, vol. 67, no. 4, pp. 1152–1175, 2023, doi: 10.3311/PPci.21388. [9] N. Tiwari and N. Satyam, “Performance evaluation of reinforced expansive soil subgrade with polypropylene fiber and geogrid,” in Sustainable Construction and Building Materials, Springer, 2022, doi: 10.1007/978-3-030-77234-5_45. [10] K. V. S. Sandeep and Ch. Sivanarayana, “An experimental study on stabilization of expansive soil by copper slag,” International Journal for Research in Applied Science and Engineering Technology, vol. 10, no. 11, pp. 431–442, 2022, doi: 10.22214/ijraset.2022.47340.
Publication Date
11/13/2026
Peer Review Type
Double-Blind Peer Review
Review Rounds: 2
Documents
Article Views
0
Total views since publication
PDF Downloads
2
Total downloads since publication
Geographic Reach
5
Digital Preservation: This article is permanently archived on Zenodo and complies with all data preservation standards across major indexing platforms.
Plagiarism Screening
This manuscript has been checked for plagiarism using TurnitinPlagiarismChecker software.
Conflict of Interest
The authors declare no conflict of interest related to this research work.
Funding Information
No funding information available for this research.
Related research in the same subject area
Loading similar articles...