IOT based Diagnosing of Fault Detection in Power Line Distribution Using Arduino

As everyone knows inside a transformer copper winding exists, copper is a costly material compare to that of aluminum. If any fault occurs then the transformer starts to burn and becomes a huge problem for power grid. When an issue happens in distribution line, it is risky for the territory. In this project a design which will distinguish the shortcoming in distribution line by looking at the Arduino, which is connected to a transformer. If power flows through this, then a subsequent signal will go to database, it depends on the number of transformer and its corresponding Arduino, if all signals go to database means power line is on ok condition. If the data signals are said to be not in specified limits so it will assume that Power line is not working properly and every Arduino has a unique area code id. The data with respect to issue event specifically stage will be sent to database through Arduino. Here there will be a microcontroller Arduino in this, IC writing computer programs is done which think about the voltage signal and will send yield through the IOT module. If any issues occur that message will be sent to the operator.