Loading article...
Loading article...
Stream/Area:
-
Subject:
-
Paper ID:
IJSREM69041
Volume:
10 |
11 |
Nov 2026
Pages:
1-6
Publication Frequency:
Monthly (12 issues per year)
License:International Journal of Scientific Research in Engineering and Management follows the Creative Commons Attribution 4.0 (CC BY 4.0) License, allowing free use and distribution with proper attribution.

Electronics and Communication Engineering
Aditya College Of Engineering And Technology

Electronics and Communication Engineering
Aditya College Of Engineering And Technology

Electronics and Communication Engineering
Aditya College Of Engineering And Technology

Electronics and Communication Engineering
Aditya College Of Engineering And Technology

Electronics and Communication Engineering
Aditya College Of Engineering And Technology
Low-cost IoT greenhouse systems built on ESP32 or similar boards and cloud apps such as Blynk are widely reported, yet a survey of nine recent studies shows recurring weaknesses: single-threshold relay control that can chatter, little or no sensor-fault handling, dependence on cloud or power availability, uncalibrated sensors, absent alerts, and no defined rules for combining manual and automatic control. This paper proposes a firmware-level architecture on the ESP32 DevKit V1 that addresses these gaps without extra hardware: signal conditioning, three sensor-fault checks with a degraded timed-irrigation mode, hysteresis with burst-and-soak pump control, a three-state mode arbiter (AUTO, MANUAL, TIMED-MANUAL) with safety interlocks, offline-first execution with non-volatile state, and rate-limited Blynk alerts. The hardware (DHT11, soil sensor and LDR via ADS1115, relay-driven pump, fan and LED, I²C LCD) is assembled and firmware is under development. In a 24-hour simulation of the control logic, relay switching fell from 231–438 to 42 per day and a frozen-sensor fault was detected in 58 s, limiting pump run-time to 500 s instead of about 65,000 s. Hardware validation is pending.
KEYWORDS
A review of nine greenhouse IoT studies exposed seven operational gaps. A firmware-only architecture for the ESP32 DevKit V1 and Blynk was proposed to address them: conditioning, fault checks with a degraded mode, hysteresis with burst-and-soak irrigation, a three-state mode arbiter with interlocks, offline-first execution with stored state, in-field calibration and rate-limited alerts. Simulation indicates fewer relay switches, rapid fault containment and unbroken control during a cloud outage. Hardware validation, a tank-level input, battery backup and crop trials are the next steps.
1. Rao, K., Srijana, K., Prasad, D., Chandrasekaran, K.: Ubiquitous greenhouse monitoring system. In: Proc. Int. Conf. Emerging Research in Electronics, Computer Science and Technology (ICERECT), IEEE (2015) 335–339 2. Fatima, N., Siddiqui, S.A., Ahmad, A.: IoT-based smart greenhouse with disease prediction using deep learning. Int. J. Adv. Comput. Sci. Appl. 12(7) (2021) 113–121 3. Parma, S.K., Alfian, Y., Manurung, E.M., Mufit, C.: IoT-based automatic plant watering system with the Blynk application. In: Proc. 4th Int. Seminar and Call for Paper (ISCP UTA'45 Jakarta 2023), SCITEPRESS (2024) 427–431. DOI 10.5220/0012584100003821 4. Sivaranjani, A.: IoT and cloud computing in a smart greenhouse. Int. J. Eng. Res. Technol. (IJERT) 14(7), NCIRTAI 2026, IJERTCONV14IS070040 5. Boussaoula, S., Jbari, A., Achmamad, A., Bellarbi, L., Yaakoubi, N.: Connected greenhouse for experimental validation of IoT control and monitoring system. EPJ Web Conf. 330 (2025) 04001. DOI 10.1051/epjconf/202533004001 6. Wayo, E., Ruang-on, S., Songsri-in, K., Tina, F.W., Nuengmatcha, P.: Design and implementation of a smart sensing IoT system for cost-effective greenhouse environmental monitoring and control. Int. J. Smart Sens. Intell. Syst. 19(1) (2026). DOI 10.2478/ijssis-2026-0008 7. Galon, M.L.Q., Tumaliwan, M.V.R., Sejera, M.M.: Automated monitoring and control system of solar greenhouse using ESP32 and Blynk application. Eng. Proc. 92(1) (2025) 57. DOI 10.3390/engproc2025092057 8. Astutik, R.P., Gunawan, B., Mas'ud, A.A.: IoT based watering system activation on smart garden. AUT J. Electr. Eng. 58(Special Issue 1) (2026) 17–26. DOI 10.22060/eej.2025.24495.5716 9. Li Zeping, Abdullah, N., Ishak, M.K.: Smart greenhouse climate control with real-time fault detection and energy-aware automation. Smart Agric. Technol. 13 (2026) 101707. DOI 10.1016/j.atech.2025.101707 10. Blynk Inc.: Blynk IoT Platform Documentation. https://docs.blynk.io
Publication Date
11/17/2026
Peer Review Type
Double-Blind Peer Review
Review Rounds: 2
Documents
Article Views
0
Total views since publication
PDF Downloads
0
Total downloads since publication
Geographic Reach
5
Digital Preservation: This article is permanently archived on Zenodo and complies with all data preservation standards across major indexing platforms.
Plagiarism Screening
This manuscript has been checked for plagiarism using TurnitinPlagiarismChecker software.
Conflict of Interest
The authors declare no conflict of interest related to this research work.
Funding Information
No funding information available for this research.
Related research in the same subject area
Loading similar articles...