Stream/Area:
-
Subject:
-
Paper ID:
IJSREM69146
Volume:
10 |
11 |
Nov 2026
Pages:
1-6
Publication Frequency:
Monthly (12 issues per year)
License:International Journal of Scientific Research in Engineering and Management follows the Creative Commons Attribution 4.0 (CC BY 4.0) License, allowing free use and distribution with proper attribution.
Electronics and Communication Engineering
SJB INSTITUTE OF TECHNOLOGY
Electronics and Communication Engineering
SJB INSTITUTE OF TECHNOLOGY
Electronics and Communication Engineering
SJB INSTITUTE OF TECHNOLOGY
Electronics and Communication Engineering
SJB INSTITUTE OF TECHNOLOGY
Electronics and Communication Engineering
SJB INSTITUTE OF TECHNOLOGY
The need for wireless data transmission has led to the growth of new communication technologies that do not rely on traditional radio-frequency links. Light-Fidelity or Li-Fi is one technology that uses light to send digital information. This paper presents a prototype that uses an ESP32 chip and Li-Fi technology to send both preset and personalized text messages as well as audio, images and video files through a light-based link.The transmitter employs an INMP441 I²S microphone. It records a 10-second mono audio clip at 16 kHz, then saves it as a WAV file on a microSD card. Text messages and file data travel through the optical link using on-off keying. Files are split into 128-byte blocks. A frame structure that includes synchronisation bytes and an XOR checksum helps the receiver recognise each packet. A CRC-32 check ensures that the files arrive intact.At the receiving side an LDR light sensor picks up the signal. An ESP32 chip then rebuilds the data that was sent. Wi-Fi and Firebase provide a dashboard for control, status updates and cloud storage. Meanwhile the optical link moves the text and file payloads from the transmitter to the receiver. This system offers a platform for people who want to explore cheap optical wireless communication and transfer of multimedia data.
KEYWORDS
A low cost ESP32-based optical communication prototype has been documented using the supplied wiring diagrams, firmware, component list and web dashboard. This ESP32-based optical communication prototype uses a GPIO-controlled light emitter software-timed frames, an LDR-based receiver, preset and custom text, ten-second I²S audio recording, SD-card file handling and Firebase integration for control and cloud storage. The current frame XOR check and end-of-file CRC-32 provide error detection. Do not recover lost chunks. The 50-ms bit interval means the best file payload rate is 14.7 bit/s once framing overhead is added and the firmware file limit is 10 MB. The next steps for this ESP32-based optical communication prototype are to calibrate or replace the LDR receiver use a current-limited emitter driver increase the optical symbol rate with timer-based transmission and faster sampling add acknowledgements and retransmission or forward error correction make sure browser-selected files and SD-card files are identical and link the receiver dashboard to data written under Received. Future experimental results, for this ESP32-based optical communication prototype should report data rate, distance, ambient illumination, alignment, packet success, byte-level file integrity and total transfer time with a stated number of trials.
[1] H. Haas, L. Yin, Y. Wang, and C. Chen, "What is LiFi?," J. Lightw. Technol., vol. 34, no. 6, pp. 1533-1544, Mar. 2016. [2] P. H. Pathak, X. Feng, P. Hu, and P. Mohapatra, "Visible light communication, networking, and sensing: A survey, potential and challenges," IEEE Commun. Surveys Tuts., vol. 17, no. 4, pp. 2047-2077, 2015. [3] D. Karunatilaka, F. Zafar, V. Kalavally, and R. Parthiban, "LED based indoor visible light communications: State of the art," IEEE Commun. Surveys Tuts., vol. 17, no. 3, pp. 1649-1678, 2015. [4] C. Lee et al., "4 Gbps direct modulation of 450 nm GaN laser for high-speed visible light communication," Opt. Express, vol. 23, no. 12, pp. 16232-16237, 2015. [5] Y.-C. Chi et al., "450-nm GaN laser diode enables high-speed visible light communication with 9-Gbps QAM-OFDM," Opt. Express, vol. 23, no. 10, pp. 13051-13059,2015. [6] T. Komine and M. Nakagawa, "Fundamental analysis for visible-light communication system using LED lights," IEEE Trans. Consum. Electron., vol. 50, no. 1, pp. 100-107, Feb. 2004. [7] H. Elgala, R. Mesleh, and H. Haas, "Indoor optical wireless communication: Potential and state-of-the-art," IEEE Commun. Mag., vol. 49, no. 9, pp. 56-62, Sep. 2011. [8] S. Rajagopal, R. D. Roberts, and S.-K. Lim, "IEEE 802.15.7 visible light communication: Modulation schemes and dimming support," IEEE Commun. Mag., vol. 50, no. 3, pp. 72-82, Mar. 2012. [9] D. Tsonev, S. Videv, and H. Haas, "Towards a 100 Gb/s visible light wireless access network," Opt. Express, vol. 23, no. 2, pp. 1627-1637, 2015. [10] M. A. Khalighi and M. Uysal, "Survey on free space optical communication: A communication theory perspective," IEEE Commun. Surveys Tuts., vol. 16, no. 4, pp. 2231-2258, 2014.
Publication Date
11/18/2026
Peer Review Type
Double-Blind Peer Review
Review Rounds: 2
Documents
Article Views
0
Total views since publication
PDF Downloads
0
Total downloads since publication
Geographic Reach
5
Digital Preservation: This article is permanently archived on Zenodo and complies with all data preservation standards across major indexing platforms.
Plagiarism Screening
This manuscript has been checked for plagiarism using TurnitinPlagiarismChecker software.
Conflict of Interest
The authors declare no conflict of interest related to this research work.
Funding Information
No funding information available for this research.
Related research in the same subject area
Loading similar articles...