Loading article...
Loading article...
Stream/Area:
-
Subject:
-
Paper ID:
IJSREM68744
Volume:
10 |
11 |
Nov 2026
Pages:
1-5
Publication Frequency:
Monthly (12 issues per year)
License:International Journal of Scientific Research in Engineering and Management follows the Creative Commons Attribution 4.0 (CC BY 4.0) License, allowing free use and distribution with proper attribution.
VLSI DESIGN
DR.SIVANTHI ADITANAR COLLEGE OF ENGINNERING
Serial links in embedded and IoT systems face two problems: channel noise can silently flip bits, and plain-text transmission can be read by anyone monitoring the line. This paper presents a low-power secure Universal Asynchronous Receiver/Transmitter (UART) architecture, built as a transmitter chain and a receiver chain joined by a single serial channel, that recovers the original data and provides reliable data transfer. In the transmitter chain, 8-bit parallel data is first passed to a CRC generator, which appends the check bits. The result is scrambled by an XOR scrambler driven by an LFSR keystream loaded with a TX seed, and the UART transmitter then adds the start, parity and stop bits and sends the frame serially. In the receiver chain, the UART receiver detects the start bit, samples the frame and rebuilds the parallel word. A descrambler with an LFSR loaded with the matching RX seed recovers the original data, and a CRC checker recomputes the CRC and compares it with the received value to ensure reliable data transfer. The data output block delivers the 8-bit word together with an error flag, which is raised on any mismatch caused by channel noise or a seed error. The design uses only shift registers, XOR gates and finite-state logic, which gives low area and low power, and clock gating of the CRC, LFSR and UART blocks cuts dynamic power when the link is idle. It is suited to FPGA and ASIC implementation in sensor networks, IoT nodes and industrial control. LFSR scrambling provides lightweight obfuscation, not strong encryption.
KEYWORDS
The proposed low-power secure UART provides reliable and lightly secured serial communication. LFSR-based scrambling randomizes the transmitted bit pattern, CRC error detection identifies corrupted frames, and the UART transmitter and receiver provide framing, synchronization and data recovery. The architecture uses only shift registers, XOR gates and finite-state logic, so it has low hardware complexity and suits VLSI implementation. Its power, area and delay remain to be measured by synthesis and simulation, and the timing violation found in the existing CRC UART must be resolved. LFSR scrambling is obfuscation only and is not a substitute for strong encryption.
[1] Buddhanoy et al., “Extracting Data-Scrambling Keys from Commercial Off-the-Shelf (COTS) NAND Flash Memory,” 2026. [Venue details to be completed]. [2] K. R. Raghavendra, H. S. Manjunath, K. B. Hegde and M. B. Veena, “Enhanced LFSR-Based Frequency Divider with Multi-Stage Feedback Selection and State Extension,” Proc. 4th IEEE Int. Conf. Knowledge Engineering and Communication Systems (ICKECS), DOI: 10.1109/ICKECS70176.2026.11527966. [3] P. S. Kartik, P. Muthukumar and L. Padmasuresh, “Comparative Performance Analysis of LFSR Techniques Using FPGA for Random Number Generation,” Proc. 9th Int. Conf. Circuit, Power and Computing Technologies (ICCPCT), 2026, pp. 2067- 2071, DOI: 10.1109/ICCPCT70290.2026.11654872. [4] J. Deng, Y. Zhang, H. Cui, H. Yang, D. Zhou, Y. Chen and X. Chen, “Lightweight PUF Authentication Protocol with NLFSR-Based Obfuscation,” Proc. Int. Conf. Electronics, Information, and Communication (ICEIC), DOI: 10.1109/ICEIC69189.2026.11386436. [5] S. Y. Hatmojo, M. D. K. H. Yuntanozra and D. Ogi, “Secure Firmware Update over UART Using AEAD-ASCON: A Lightweight Cryptographic Framework for Constrained IoT Devices,” Proc. IEEE Int. Conf. Industry 4.0, AI, and Communications Technology (IAICT), Jul. 2026, pp. 629-636, DOI: 10.1109/IAICT71158.2026.11620842. [6] P. B. Swetha, A. Gayathri, B. Renuka, D. Shirisha, C. S.R. Vennakandla and S. F. Sultana, “Fault-Tolerant UART with CRC-Based Error Detection,” Proc. 7th Int. Conf. Mobile Computing and Sustainable Informatics (ICMCSI), 2026, pp. 1684-1689, DOI: 10.1109/ICMCSI67283.2026.11412734. [7] S. Karthigaa, M. Premalatha, S. Yuvikaa Shree, V. Jayanthimani, J. M. Keshika and M. S. Vinotheni, “Design and Simulation of UART with Configurable Parity,” Proc. 5th Int. Conf. Communication, Computing and Electronics Systems (ICCCES), 2026, , DOI: 10.1109/ICCCES62661.2026.11436434. [8] S. Dhanasekar, A. K. Boopathy, A. V. P. Kumar, G. V. Amirth and D. Madhumitha, “Design of Low Power UART Architecture with FIFO Buffering for High-Speed Applications,” Proc. Int. Conf. Signal Processing and Electronics Design (ICSPED), 2026, pp. 182-188, DOI: 10.1109/ICSPED65817.2026.11448415. [9] E. S. Rajavel, V. G. Rajkumar, M. S. Kashwin, V. J. Suthahar, A. Pravin and D. J. J. D. Daniel, “UART Design and Verification of Compatible Baud Rate Communication,” Proc. Third Int. Conf. Networking and Communications (ICNWC), 2026, DOI: 10.1109/ICNWC68145.2026.11518143.
Publication Date
11/5/2026
Peer Review Type
Double-Blind Peer Review
Review Rounds: 2
Documents
Article Views
0
Total views since publication
PDF Downloads
7
Total downloads since publication
Geographic Reach
5
Digital Preservation: This article is permanently archived on Zenodo and complies with all data preservation standards across major indexing platforms.
Plagiarism Screening
This manuscript has been checked for plagiarism using TurnitinPlagiarismChecker software.
Conflict of Interest
The authors declare no conflict of interest related to this research work.
Funding Information
No funding information available for this research.
Related research in the same subject area
Loading similar articles...