Loading article...
Loading article...
Stream/Area:
-
Subject:
-
Paper ID:
IJSREM12603
Volume:
6 |
4 |
Apr 2022
Pages:
Publication Frequency:
Monthly (12 issues per year)
License:International Journal of Scientific Research in Engineering and Management follows the Creative Commons Attribution 4.0 (CC BY 4.0) License, allowing free use and distribution with proper attribution.
The experimental and analytical results of an analysis of the three key cutting parameters that determines surface roughness and cutting force —cutting speed, feed rate, and depth of cut—are presented in this paper. Design-of-experiment methods was used to plan a two-level, three-parameter experiment. Aluminum was used as the work material (Al 6061). The data was analyzed using the Pareto anova approach. Following that, regression analysis was used to create predictive models for each material.
KEYWORDS
Publication Date
4/28/2022
Peer Review Type
Double-Blind Peer Review
Review Rounds: 2
Documents
Article Views
0
Total views since publication
PDF Downloads
2
Total downloads since publication
Geographic Reach
5
Digital Preservation: This article is permanently archived on Zenodo and complies with all data preservation standards across major indexing platforms.
Plagiarism Screening
This manuscript has been checked for plagiarism using TurnitinPlagiarismChecker software.
Conflict of Interest
The authors declare no conflict of interest related to this research work.
Funding Information
No funding information available for this research.
Related research in the same subject area
Loading similar articles...