Loading article...
Loading article...
Stream/Area:
-
Subject:
-
Paper ID:
IJSREM33968
Volume:
8 |
5 |
May 2024
Pages:
Publication Frequency:
Monthly (12 issues per year)
License:International Journal of Scientific Research in Engineering and Management follows the Creative Commons Attribution 4.0 (CC BY 4.0) License, allowing free use and distribution with proper attribution.
In this experimental research work we have studied the major process parameters involved in PVC pipe manufacturing. After the extrusion Process Many defects have been observed like, Wall thickness, uneven diameter, rough surface and low tensile strength. Out of these, we focused on the wall thickness of pipes, Observed and analyzed all the relevant process parameter with the help of Taguchi method. With the help of statistical evolution software Minitab-18 and using L9 orthogonal array with 4 factors, studied and optimized process parameter has been obtained, which results higher productivity by lowering the defects.
KEYWORDS
Publication Date
12/31/45426
Peer Review Type
Double-Blind Peer Review
Review Rounds: 2
Documents
Article Views
0
Total views since publication
PDF Downloads
0
Total downloads since publication
Geographic Reach
5
Digital Preservation: This article is permanently archived on Zenodo and complies with all data preservation standards across major indexing platforms.
Plagiarism Screening
This manuscript has been checked for plagiarism using TurnitinPlagiarismChecker software.
Conflict of Interest
The authors declare no conflict of interest related to this research work.
Funding Information
No funding information available for this research.
Related research in the same subject area
Loading similar articles...