Loading article...
Loading article...
Stream/Area:
-
Subject:
-
Paper ID:
10.55041/IJSREM13958
Volume:
6 |
5 |
May 2022
Pages:
Publication Frequency:
Monthly (12 issues per year)
License:International Journal of Scientific Research in Engineering and Management follows the Creative Commons Attribution 4.0 (CC BY 4.0) License, allowing free use and distribution with proper attribution.
– In this paper, the Taguchi method has been applied to optimize the machining performance in terms of surface roughness of the product, with aluminium work piece. Two different types of cutting tools were used of which were HSS and Carbide for experiment on a VMC machine. Taguchi’s L-16 orthogonal array is used for the experimentation. The factors considered for experimentation are spindle speed, feed rate, depth of cut and tool type. Signal-to-noise (S/N) ratio and analysis of variance (ANOVA) were employed to analyse the effect of these milling parameters.
KEYWORDS
Publication Date
5/29/2022
Peer Review Type
Double-Blind Peer Review
Review Rounds: 2
Documents
Article Views
0
Total views since publication
PDF Downloads
1
Total downloads since publication
Geographic Reach
5
Digital Preservation: This article is permanently archived on Zenodo and complies with all data preservation standards across major indexing platforms.
Plagiarism Screening
This manuscript has been checked for plagiarism using TurnitinPlagiarismChecker software.
Conflict of Interest
The authors declare no conflict of interest related to this research work.
Funding Information
No funding information available for this research.
Related research in the same subject area
Loading similar articles...