Loading article...
Loading article...
Stream/Area:
-
Subject:
-
Paper ID:
IJSREM68944
Volume:
10 |
11 |
Nov 2026
Pages:
1-10
Publication Frequency:
Monthly (12 issues per year)
License:International Journal of Scientific Research in Engineering and Management follows the Creative Commons Attribution 4.0 (CC BY 4.0) License, allowing free use and distribution with proper attribution.
Department of Civil Engineering
Sanketika Vidya Parishad Engineering College, P.M. Palem, Visakhapatnam – 530041, Andhra Pradesh, India
Department of Civil Engineering
Sanketika Vidya Parishad Engineering College, P.M. Palem, Visakhapatnam – 530041, Andhra Pradesh, India
The growing demand for durable pavement infrastructure and the environmental burden associated with ordinary Portland cement (OPC) have encouraged the use of supplementary cementitious materials in pavement quality concrete (PQC). This experimental study evaluates M40 PQC incorporating ground granulated blast furnace slag (GGBFS) at replacement levels of 60%, 65% and 70% of the binder, compared with a conventional OPC–fly ash control mix. Fresh properties, compressive strength, flexural strength, resistance to 5% sulphuric acid and 5% sodium sulphate exposure, abrasion resistance and drying shrinkage were investigated. The GGBFS mixtures achieved 25 mm slump with fresh densities of 2482.73–2514.87 kg/m³. At 28 days, compressive strength was 7.5–7.9% lower than the respective controls; however, at 90 days, the GGBFS mixtures attained 55.53–56.24 MPa, exceeding their controls by 17.3–20.6%. Flexural strength at 90 days increased with GGBFS content, reaching 10.56 MPa at 70% replacement. The GGBFS mixtures also exhibited higher residual strength after chemical exposure and higher reported abrasion resistance, while drying-shrinkage values remained close to the control. The findings indicate that high-volume GGBFS can be a technically promising binder for M40 PQC when adequate curing and project-specific mix verification are ensured.
KEYWORDS
1. Workable M40 PQC incorporating 60–70% GGBFS was produced using a PCE-based superplasticizer dosage of 0.40% by binder mass. The GGBFS mixes recorded 25 mm slump, fresh density of 2482.73–2514.87 kg/m³ and 1.00% air content. 2. At 28 days, the GGBFS mixtures exhibited 7.5–7.9% lower compressive strength than their corresponding controls. At 90 days, their compressive strengths reached 55.53–56.24 MPa, representing improvements of 17.3–20.6% over the controls. 3. Flexural strength at 28 days remained comparable with the conventional mix. At 90 days, the 70% GGBFS mix achieved the highest value of 10.56 MPa, followed by the 65% and 60% mixes at 9.77 and 9.00 MPa. 4. After 5% H₂SO₄ exposure, the 70% GGBFS mix recorded the highest 90-day residual compressive strength (28.82 MPa), 21.3% above the control. Under 5% Na₂SO₄ exposure, all GGBFS mixes exceeded the control at 90 days. 5. Reported abrasion values for the GGBFS mixtures were 33.3–40.0% higher than their respective controls. Drying-shrinkage length-change values were close to the conventional mix, indicating comparable measured dimensional change at 28 days. 6. Within the limits of the laboratory programme, high-volume GGBFS replacement of 60–70% is promising for M40 PQC. The 70% mix provided the strongest overall response in selected 90-day performance measures, but adequate curing and project-specific validation are essential.
[1] Bhatt A, Kumar S, Prasad P, Sahu A, Kumar P, Hussein AB. Mechanical, Durability and Microstructural Performance of OPC–GGBFS–FGD Gypsum Ternary Concrete: Identification of an Operational Sulfate Activation Threshold. Materials. 2026;19(14):2962. https://doi.org/10.3390/ma19142962 [2] Karabaş B, Uzer AU. Road Subgrade Stabilization Using Ground Granulated Blast Furnace Slag: Pavement Design, Cost Optimization, and CO2 Emission Reduction. Materials. 2026;19(21):4639. https://doi.org/10.3390/ma19214639 [3] Elhussainy MS, Ibrahim EK. Effect of Acid Attack on the Performance of Reactive Powder Concrete Incorporating Supplementary Cementitious Materials. Journal of Engineering and Sustainable Development. 2026;30(1):66–74. https://doi.org/10.31272/jeasd.2227 [4] Chittibabu B, Durgarani K. Performance Evaluation of Drying Shrinkage and Durability in Pavement Quality Concrete with Recycled Aggregate, GGBS and I-Crete. Global NEST Journal. 2025;27(3):1–11. https://doi.org/10.30955/gnj.06845 [5] Wasil I, Ganvir D, Chopra T, Singh MK. Influence of GGBFS and Processed Coarse RAP in Pavement Quality Concrete. In: Pavement Systems Engineering. Singapore: Springer Nature; 2025. https://doi.org/10.1007/978-981-96-8110-5_14 [6] Akhlaq H, Peng T, Ajmal MM, Khan MS, Riaz M. Impact of GGBS on the Rheology and Mechanical Behavior of Pumpable Concrete. Frontiers in Materials. 2025;12:1614951. https://doi.org/10.3389/fmats.2025.1614951 [7] Scully K, Drewniok M. Sulfate Addition to Ground Granulated Blast-furnace Slag for use as a Supplementary Cementitious Material in Concrete. International Conference on Durability of Concrete Structures (ICDCS); 2025. https://doi.org/10.5703/1288284318162 [8] Kumar A. Effect of Ground Granulated Blast Slag and Temperature Curing on the Strength of Fly Ash-based Geopolymer Concrete. Engineering, Technology & Applied Science Research. 2024;14(2):13319–23. [9] Yahyaee T, Elize HS. A comprehensive study on mechanical properties, durability, and environmental impact of fiber-reinforced concrete incorporating ground granulated blast furnace slag. Case Studies in Construction Materials. 2024;20(3):1–18. [10] Patel VJ, Juremalani J, Kumavat HR. Incorporation of High Volume Ground Granulated Slag from Blast Furnaces in Pavement Quality Concrete. Engineering, Technology & Applied Science Research. 2024;14(4):14888–93. https://doi.org/10.48084/etasr.7466
Publication Date
11/13/2026
Peer Review Type
Double-Blind Peer Review
Review Rounds: 2
Documents
Article Views
1
Total views since publication
PDF Downloads
3
Total downloads since publication
Geographic Reach
5
Digital Preservation: This article is permanently archived on Zenodo and complies with all data preservation standards across major indexing platforms.
Plagiarism Screening
This manuscript has been checked for plagiarism using TurnitinPlagiarismChecker software.
Conflict of Interest
The authors declare no conflict of interest related to this research work.
Funding Information
No funding information available for this research.
Related research in the same subject area
Loading similar articles...