Loading article...
Loading article...
Stream/Area:
-
Subject:
-
Paper ID:
IJSREM69188
Volume:
10 |
11 |
Nov 2026
Pages:
1-8
Publication Frequency:
Monthly (12 issues per year)
License:International Journal of Scientific Research in Engineering and Management follows the Creative Commons Attribution 4.0 (CC BY 4.0) License, allowing free use and distribution with proper attribution.
Electronics Engineering
M.S.Bidve Engineering College Latur
Electronics Engineering
M.S.Bidve Engineering College Latur
Conventional residential electrical wiring relies on fixed mechanical wall switches that require physical proximity and lack remote accessibility, posing inconvenience for elderly or mobility-impaired occupants and hindering proactive energy conservation. This research paper presents the design, circuit architecture, and implementation of a cost-effective Touch and Remote Control Home Automation System engineered around an 8-bit Arduino Nano microcontroller, an HC-05 wireless Bluetooth serial transceiver, and an opto-isolated 4-channel relay switching stage. By combining a touch-responsive mobile graphical user interface (GUI) with short-range wireless remote control over the Universal Asynchronous Receiver-Transmitter (UART) Serial Port Profile (SPP), the system enables instantaneous, non-line-of-sight actuation of four distinct domestic electrical loads: a main room bulb, an air conditioner (AC) control circuit, a study lamp, and a ceiling fan. A dedicated 5 V regulated supply rail (USB1) powers the wireless transceiver and electromechanical relay coils in parallel with the controller logic, preventing voltage sags during multi-channel switching transients. Experimental verification confirms reliable command execution, galvanic isolation between low-voltage control electronics and mains-fed appliance circuits, and sub-100 ms switching response across indoor residential environments.
KEYWORDS
This paper presented the design, circuit analysis, and experimental validation of a Touch and Remote Control Home Automation System built upon an Arduino Nano microcontroller, an HC-05 Bluetooth serial module, and a 4-channel relay driver board. By pairing an intuitive capacitive touchscreen interface with reliable 2.4 GHz UART wireless communication, the system provides effortless, non-line-of-sight switching for a main bulb, air conditioner control circuit, study lamp, and fan. Careful power bus engineering—specifically feeding the 4-channel relay VCC and HC-05 VCC from a shared 5 V USB1 rail—ensures noise-free operation under full multi-channel load. The resulting architecture delivers a low-cost, modular, and practical foundation for modern residential automation.
1. IEEE Standards Association, IEEE Std 802.15.1: Wireless Medium Access Control (MAC) and Physical Layer (PHY) Specifications for Wireless Personal Area Networks (WPANs), Institute of Electrical and Electronics Engineers, New York, NY, USA. 2. Arduino AG, Arduino Nano Technical Reference Manual and ATmega328P Microcontroller Pinout Specification, Arduino Hardware Documentation. 3. Guangzhou HC Information Technology Co., Ltd., HC-05 Bluetooth-to-Serial Port Module Datasheet and AT Command Set Specification, Technical Reference Manual.
Publication Date
11/18/2026
Peer Review Type
Double-Blind Peer Review
Review Rounds: 2
Documents
Article Views
0
Total views since publication
PDF Downloads
1
Total downloads since publication
Geographic Reach
5
Digital Preservation: This article is permanently archived on Zenodo and complies with all data preservation standards across major indexing platforms.
Plagiarism Screening
This manuscript has been checked for plagiarism using TurnitinPlagiarismChecker software.
Conflict of Interest
The authors declare no conflict of interest related to this research work.
Funding Information
No funding information available for this research.
Related research in the same subject area
Loading similar articles...